Strong winds recently flattened many fields partially or completely. Even when the plants have risen again, their angled growth can still cause problems during harvesting. Westerink Parts has once again purchased pallets of knife sets, offering the correct quality at a competitive price so you can complete the maize harvest without problems.
Watch the video in which Bas shows the complete tungsten-hardened Kemper knife sets on the pallet.
Everything in one box: no searching for bolts and nuts
When replacing the knives on a Kemper maize header, you do not want to discover halfway through the job that you are short of a few bolts or nuts. Westerink Parts therefore supplies these knife sets as one complete package. Whether for the Kemper 400 series , with two large drums in one set, or the Kemper M315 , with two small drums in one set, the package contains everything you need, including reamers and all fastening materials.
Longer service life with tungsten carbide
Maize harvesting places extreme demands on the cutting tools. To prevent the knives and reamers from losing their edge after only a few days, these sets have a high-quality upgrade. Both the knives and reamers have an extra-hard tip coated with a wear-resistant tungsten-carbide layer. This provides:
-
A long service life.
-
Knives that remain sharp during operation.
-
A consistently frayed stubble that decomposes easily after harvest.
In the video, Bas shows the sets fresh from the pallet and available directly from our own stock.
What do you need?
For the Kemper 345, you need three sets of 79040 .
This header has six small drums.
For the Kemper 360, you need four sets of 79040 .
This header has eight small drums.
For the Kemper 375, you need five sets of 79040 .
This header has ten small drums.
For the Kemper 390, you need six sets of 79040 .
This header has twelve small drums.
For the Kemper 460, you need two sets of 89940 .
This header has four large drums.
For the Kemper 490, you need three sets of 89940 .
This header has six large drums.
For the Kemper 475, you need two sets of 89940 and one set of 79040 .
This header has four large drums and two small drums.
For the Kemper 445 and 4500, you need one messensetm4500 knife set.
This header has two large drums and two small drums.
In brief
-
Contents: Fully complete sets with knives, reamers, bolts and nuts.
-
Quality: A sprayed tungsten-carbide layer on the tips provides extreme wear resistance.
-
Models: Available directly for the Kemper M315 and the Kemper 400 series and the Kemper 445 / 4500
-
Your advantage: No need to order loose parts, fast installation and a considerably longer service life in maize.
